1. Interception - You have to ensure you intercept the traffic outside the tunnels, otherwise you won't get any compression. Hardware based switches like the Cat6K cannot use WCCP on tunnel interfaces. Software based routers can do interception on tunnel interfaces, but don't scale as much as the hardware assisted platforms.
2. Packet size - if you are getting excessive fragmentation, try lowering the Optimized MSS value on the WAEs to under what you need for headers. WAAS default is 1432.
Other then that, what you have is a pretty normal installation situation.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...