On the WAE, I configured l2-redirect and mask-assign based on a config example I came across. I don't quite understand the function of these two keywords. Below is the Command Reference for the "wccp tcp-promiscuous" command:
Re: WAE - Clarification on "wccp tcp-promiscuous" command
The WCCP configuration on the WAE is correct, however on the 6500 you should avoid the use of outbound redirection and the 'ip wccp redirect exclude in' command. Both of these commands cause a portion of the WCCP redirection to happen in software (versus hardware).
Instead of configuring outbound redirection, you can move that service group to the server-facing interfaces as inbound redirection. By only using inbound redirection, you also no longer need the 'redirect exclude in' command.
This document covers the important troubleshooting data to be collected and data collection procedures when you experience an issue with ACI fabric. The collection of the relevant troubleshooting data is very critical to root cause the issue and...
There are certain situations in where an On-Demand Techsupport is not able to be performed. In such cases, a local techsupport can be collected instead for either the APIC or an ACI switch. This document outlines this...
Webcast: Evolution of Data Center: From Classic Ethernet to VXLAN
(Live Webcast Tuesday May 15, 2018 at 10 am Pacific/ 1 pm Eastern / 7 pm Paris)
Register today for this live Cisco Support Community webcast.