Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
kmr
Community Member

WAE disk_check.sh and disk_clean.pl

I ran the disk_chck.sh script on a WAE and disk_status.txt says 'device /dev/md2 (/state) is File system errors were detected. <snip>'. The readme for disk_clean.pl says 'Although the device is on the network, it will be offline in the CM GUI. Deleting the partitions also deleted the CMS database on this device, so you will need to delete the device on the CM, then re-enable the commands on the CLI of the device.'

What 're-enable' commands? I should execute this on the CLI of which device (WAE or CM)?

TIA.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: WAE disk_check.sh and disk_clean.pl

The procedure at the following URL should get everything back up and running after the disk clean script has been run.

http://www.cisco.com/univercd/cc/td/doc/product/webscale/waas/waas407/cfgd/maint.htm#wp1105458

Hope this helps.

Greg Scarlett

APAC TAC

1 REPLY
Cisco Employee

Re: WAE disk_check.sh and disk_clean.pl

The procedure at the following URL should get everything back up and running after the disk clean script has been run.

http://www.cisco.com/univercd/cc/td/doc/product/webscale/waas/waas407/cfgd/maint.htm#wp1105458

Hope this helps.

Greg Scarlett

APAC TAC

160
Views
0
Helpful
1
Replies
CreatePlease to create content