Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAE link redundancy

Hi Sir,

I have one unit Cisco WAE-612 to be deployed at a data center, which consists of two core/distribution switches. I'm configuring WCCPv2 to intercept traffic for optimization.

The WAE-612 has two 10/100/1000BASE-T interfaces. At first, I'm planning to connect only one GE interface to one of the distribution switches on a single VLAN.

If link redundancy is required using both GE interfaces, how do I connect the WAE now? Each GE goes to one of the core/dist. switches? WCCP run on two subnets?

Please advise.

Thank you.

B.Rgds,

Lim TS

2 REPLIES
Silver

Re: WAE link redundancy

They are in seperate networks.Cisco WAE devices can be transparently deployed in-line using an optional 4-port network interface card with the ability to fail-to-wire in the event of a software or hardware failure, preserving traffic flow in both directions and ensuring no loss of network connectivity. Refer URL

http://cisco.com/en/US/products/ps6474/products_data_sheet0900aecd80329e39.html

New Member

Re: WAE link redundancy

Hi Carlos,

In my data center scenario, how can I utilize both the GE interfaces on the WAE?

Do you typically recommend in-line deployment over interception deployment?

Thank you.

B.Rgds,

Lim TS

108
Views
0
Helpful
2
Replies