Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

WAF - "How to" question

I've read the firewall administrator's guide and I'm still not sure that I know how to get the WAF to answer for multiple ip addresses. For example, if I want the following to happen:

192.168.1.101:80 (WAF) -> 172.16.1.1 (Backend server)

192.168.1.102:443 (WAF) -> 172.16.1.2 (Backend server)

Are those 2 ip addresses configured from the console on the WAF? Does anyone have any insight about how to configure the WAF to redirect for multiple ip addresses?

Thank you,

Jim

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: WAF - "How to" question

You need to first configure the additional IP addresses using the console (SSH or video), then configure the policy to accept those IP addresses using the Manager. For more information on doing the console configuration, please see:

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/ace_waf/v60/administration/guide/axg_admin_initialconfig.html#wp1090496

2 REPLIES
New Member

Re: WAF - "How to" question

You need to first configure the additional IP addresses using the console (SSH or video), then configure the policy to accept those IP addresses using the Manager. For more information on doing the console configuration, please see:

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/ace_waf/v60/administration/guide/axg_admin_initialconfig.html#wp1090496

Bronze

Re: WAF - "How to" question

Thank you, this did the trick and was very straightforward. Only thing to add is that the order is important. I put in the rules through the manager first and when deploying it the Reactor process shutdown. Lesson learned - I'll always put in the ip address through the console first.

Thanks for your help!

134
Views
0
Helpful
2
Replies