Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WCCP blocking all ports

Weird one, bluecoat mach5 with 6509 with 12.2(18)SXF2 ios code. for some unknown reason WCCP started blocking all ports to server that was in my access-list

deny ip 10.122.50.0 0.0.1.255 any

deny ip 10.122.40.0 0.0.1.255 10.120.50.0 0.0.1.255

permit ip host 10.122.41.240 any

permit ip host 10.120.41.240 any

only directing wccp between two hosts, all other traffice on this vlan40 is dropped.

the second I put the wccp "in" onto the vlan40 interface, rdp, web, were dropped. I am not re-directing those ports on the bluecoat. if request to rdp into 10.122.41.240 came from local subnet, RDP was allowed. outside that subnet or outside that IP range denied.

Anybody seen something weird like this happen with wccp? I am using wccp service groups, not port 80/8080 redirect. Bluecoat determines what ports are being re-directed. mach5 is a WAFS product.

Also, is there more than 3 or 4 documents on the cisco site about WCCP? I have 4 docs about implementing wccp and that is all I could find.

2 REPLIES
Silver

Re: WCCP blocking all ports

See the under-mentioned URL. It indicates those ports and protocols that are not to be filtered:-

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/120newft/120limit/120s/120s11/12s_wccp.htm#xtocid16540

New Member

Re: WCCP blocking all ports

thanks for the reply. Issue was I needed to define the WCCP ports on the Bluecoat Mach5 in the WCCP config. BC support said this wasn't necessary, but it is.

375
Views
0
Helpful
2
Replies