Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

WCCP causing 7200 CPU load

I have a 7206VXR (NPE-G2) that is using WCCP to redirect traffic to a WAE cluster running WAAS software. average of 60 Meg of traffic.

I am looking for some help in locating any documents that would help with recommendations on router requirements to support this setup. Or documents that would point me into another setup.

When there is about 70 Meg of traffic traversing the LAN interface going out to the WAN/MAN connections the router cpu runs about 60+%.

290
Views
0
Helpful
0
Replies
CreatePlease to create content