Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WCCP configuration

Dearss

I am trying to configure traffic redirection for WAAS. from one side i have the WAE attached to a layer 2 switch and the default gateway is the router. by doing router on a stick. on the edge side, i have a WAE attched to a layer 3 switch where the SVI is the default gateway. so i have to configure the wccp on the switch. the topology is a hub and smoke topology and running OSPF with the spokes. configuring WCCP on a switch is different than a router and i want the traffic on the link where the WAE is installed. It is a little tricky.

Any suggestions kindly, check my diagram in the attachment

2 REPLIES
Silver

Re: WCCP configuration

On a switch you will use layer 2 redirection.

On the WAE configure as follows:

wccp tcp-promiscuous router-list 1 L2-redirect mask-assign

On the switch place ip wccp 61 redirect in your client facing interfaces

and ip wccp 62 redirect in uplink to wan

New Member

Re: WCCP configuration

L2 redirection on the switch connected to the edge WAE. the configuration will be:

wccp web-cash redirect in under the user SVI?

wccp tcp-promiscuous router-list 1 L2-redirect mask-assign on the core WAE.

ip wccp 61 under the subinterface of the router connected to the user?

ip wccp 62 redirect on serial interface from the core side?

please clarify and if you have a document that will help me understand well the configuration

353
Views
0
Helpful
2
Replies