I have a question on wccp support on 1700 router running ipbase image. once wccp ver 2 and service 61 and 62 are enabled on the router, it forms a service group with the engine and it sees the wae but once redirection 61 on the lan interface and 62 on the wan interface is enabled, no redirection takes place. the redirection doesnt occur and no traffic is redirected. What could be the problem. Does it have anything to do with the image running on the router?
i know the 1700 is not a recommended platform for wccp or waas but at least it should still redirect traffic. the image running on the router is 12.3 ipbase. perhaps this does not really support wccp redirection on the interface. it takes the command but no redirection takes place.
What version of 12.3 and what version of WAAS? I would recommend looking at least IOS version 12.3(13) or 12.3(14)T5 depending on what train you are using. Do you mind posting your configs from the WAEs and router? That might help determine what is happening.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...