WCCP with Layer2

[Amol Akadkar]

Hi,

I want to configure WCCP on Layer2 Redirection on Cisco Router 3800, but only GRE mode is working layer2 redirect is not comming up.

Cisco Router Details: Cisco IOS Software, 3800 Software (C3845-SPSERVICESK9-M), Version 12.4(15)T7, RELEASE

Proposed diagram is attached.

WCCP will be configured on LAN Interface of Router.

Observation: if cashing engine connected on (L3 Switch) LAN side of router, Layer2 Redirection is working fine. But if cashing engine connected on additional interface of router layer2 mode is not working.

[nkarthikeyan]

can you share you configurations @ you router?

also if poosible paste the parameters you have set on caching engine?

Regards

Karthik

[Amol Akadkar]

Hi Karthik,

Please find commands on Router as below and WCCP configuration on Cashing Engines screen is attached --

Router Configuration

Router (config)# access-list 101 permit ip 172.60.10.0 0.0.0.255 172.80.10.0 0.0.0.255

Router (config)# ip wccp 53 redirect-list 101

Router (config)# ip wccp 54 redirect-list 101

Router (config)# interface FastEthernet0/0 (LAN Interface of Router)

Router (config)# ip wccp 53 redirect in

Router (config)# ip wccp 54 redirect in

Router (config)# end

[nkarthikeyan]

Hi Amol,

Have you tried enabling accelarated command in global command?

Regards

Karthik

[Amol Akadkar]

Hi Karthik,

Thanks for quick response.

Issue is WCCP Layer2 is Initializing. If mode change it to GRE then it works fine.

Regards,

Amol

[Amol Akadkar]

Hi Karthik,

Any update on the issue.

[nkarthikeyan]

I have very limted option to try out in lab.... let me try my best to figure out the issue..

Regards

Karthik

[Amol Akadkar]

Hi Karthik,

Thanks for quick response.

Issue is WCCP Layer2 is Initializing. If mode change it to GRE then it works fine.

Regards,

Amol