Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

What does WAN Utilization setting on WAFS intend for

Hi everyone,

There are two parameters in "WAN Utilization settings" on WAFS configuration, "Maximum allocated bandwidth" and "Minimum roundtrip delay".

I think those parameters are used to get WAFS throttled traffic over the connection between peer WAFS(WAE).

And configuring those parameters are optional, so I do not have to configure them that means I can use them with default value even if the actual physical bandwidth of physical WAN link is more high than default value (1544KB).

I also guess those parameters might be used to prepare appropriate buffer size by WAFS to control traffic rare from/to the WAFS(WAE) and to avoid congestion at point of WAFS.

I have some questions about it.

Q1: Is my understanding correct ?

Q2: Can I use default value regardless of actual physical WAN link between the WAEs or should I configure appropriate value based on actual environment ?

Q3: What does those vale intend for, if my understanding is wrong ?

Would you please assist me if you have any information.

Best regards,

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: What does WAN Utilization setting on WAFS intend for

Hello,

The bandwidth and latency settings in the connectivity directive should be set correctly. This allows CIFS acceleration to tune itself to the WAN conditions presented, and also ensures preposition jobs don't flood WAN links with excessive amounts of traffic.

Best regards,

Joel

3 REPLIES
New Member

Re: What does WAN Utilization setting on WAFS intend for

Hello,

The bandwidth and latency settings in the connectivity directive should be set correctly. This allows CIFS acceleration to tune itself to the WAN conditions presented, and also ensures preposition jobs don't flood WAN links with excessive amounts of traffic.

Best regards,

Joel

Bronze

Re: What does WAN Utilization setting on WAFS intend for

Hi Joel,

Thank you very much for your reply.

I understand it.

Best regards,

New Member

Re: What does WAN Utilization setting on WAFS intend for

We just installed a point to point T3. Due to TCP limitations we are not utilizing the bandwidth. Everything I've read says I will need to tune the individual workstions/servers or purchase an appliance to overcome this. My question is: is there another type of circuit we should have installed rather than a point-to-point T3 that will perform as well but not have the TCP issues due to the RTT?

Thanks,

Chris

105
Views
0
Helpful
3
Replies