I am trying to change my Ata 186 from a IOS that handle SCCP to a image that can handle SIP-communitation.
I have put the useTFTP to 0, and as you can see, tries to use the ata186us, to change the IOS. (See under) But, I only get "configuration failed". I have altso tried with several TFTP-servers, with the same result. Any suggestions?
Very grateful for any help! :)
C:\Documents and Settings\NovaNett\Mine dokumenter\Kaj\KaMy\Cisco\ata18x-v2-16-1 -030709a-2>ata186us -any -d1 ata18x-v2-16-1-030709a.zup ata186us version 2.0 Using Host: LapTopKaj with IP: 172.20.101.82 as upgrade server This machine IP: 172.20.101.82 Upgrade Server Port: 8000 Data stream 0 port: 8500 image found: code -- ata186.itsp2.v2.16
Using dialpad of your telephone (attached to your ATA box), press ATA button to go to main menu, and enter:
100#172*20*101*82*8000# (to upgrade code)
NOTE: Pressing 123# will announce your code's version number. You can later verify that you have upgraded your ATA box.
This program runs continuously; Press <ctrl>-c to abort. Upgrade server ready... Thu Nov 19 09:47:20 2009 172.20.101.80 -> <udp: 172.20.101.82 8500 123> Begin uploading code to 172.20.101.80 (Thu Nov 19 09:47:20 2009) ... Done uploading code to 172.20.101.80 (Thu Nov 19 09:47:23 2009)
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...