I recently purchased a PoE switch to replace an older non-managed switch and am having some very strange occurrences when I connect my ATA-186 devices to it. Basically, what is happening is if I connect the ATA and a PC to a switch other than my ESW 520 I can ping the interfaces and everything works fine. As soon as I connect the ESW 520 in ANY WAY to the other switch, the ATA stops responding to ping requests and has to be physically reset.
Has anyone experienced this problem before? I have two ATA 186 devices that I'd like to get back up and running, but cannot due to the ethernet interfaces dying off each time they are connected to the PoE switch.
Article ID:1966 Network Address Translation (NAT) Settings for Lines on
PAP2T and SPA3102 Phone Adapters Objective The objective of this
document is to configure Network Address Translation (NAT) settings for
the lines of communication on the PAP2T and SP...
Article ID:2742 Speed Dial Settings on SPA100 Series Objective Speed
Dial Buttons are often used to make the process of calling regularly
used contacts quicker and with one button. This option is used in place
of dialing the entire phone number in. This h...
Article ID:2676 Firmware Upgrade on SPA112 and SPA122 Objective To
upgrade the firmware a specific file must be downloaded from the
Internet and uploaded to the device. Upgrading your devices can be very
useful. Firmware upgrades can fix software bugs, im...