I live in a condo building, and am using the Cisco ATA SPA112. How would I set this up so that my entry phone will ring through onto my VOIP.MS line? My ATA connects to my base station, and the rest of my phones are all cordless. I have nothing plugged into the ma bell outlets.
Basically, I have one line in a bedroom, it is hardwired to the entry phone system, and gatehouse. I have it plugged into a normal phone. If someone uses my buzzer, that phone only rings. I want to mesh that into my ATA system if possible, so that all the phones ring, and I don't have to have one phone just to answer the gatehouse and lobby call system.
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...