When we were RC-certified, we provided an admin-password with the RC-profile. On a unit with profile: pending, hos do you get to the admin pages? Upon entering /admin you just get a 403 but without being presented with the possibility to specify a password for the page. Is there a way to get to the admin-pages on a "pending" unit?
Re: Getting to admin page on non-provisioned RC-model
This is not possible. It is disabled because of security reasons, we dont wan't people to change (or hack) parameters of an RC unit until it is provisioned by the service provider. When provisioned the Service provider decides the level of security he want to give to its configuration. This is provided as a way to protect Service Provider (who buys the RC unit as a locked device) business.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...