How do I configure the SPA3102 to not check for a dial tone?
We have several door boxes that simulate a POTS line to a phone system. Now that we have replaced our traditional PBX with an IP based system, we are using the SPA3102 to direct push buttons calls at a door box into the phone system. This works correctly. However, if we try to call out to the door box, the connection fails. Hook a traditional phone line to the device and it will connect. The absence of a dial tone appears to be the issue. How can I configure the SPA3102 to not check for a dial tone when receiving an outbound call request?
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...