I would like to use a SPA8800 to make an analog line available to a VoIP phone (because at the location of the phone only LAN is available and no phone line). This is, when the line rings, the VoIP phone should ring. It would be nice to have if the VoIP phone could also use the line to dial out.
I already have the SPA8800, furthermore I have a SPA941 phone.
PSTN ----- line ----- SPA8800 ----- Ethernet ----- SPA941
Can you give advice on the necessary configuration for the SPA8800 for this setup? The few guides I could found were all for the other way around (Internet ----- SPA8800 ----- analog phone).
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...