Thank you for your quick reply! This information looks like a policy of company for this products. But actually it's not for all Linksys products. I contacted with the tech.support of Linksys about WAP54G. They said there is no problem to set netmask 255.255.0.0 for Static IP on WAP54G. This settings were checked in their test lab. That is why I asked the question for this concrete products (not for all Linksys products).
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...