Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Newly fetched settings getting reset all the time (provisioning of SPA 122)

The initial configuration works and is pretty much a sample file that sets some defaults and resets the provisioning rule to fetch an encrypted file with this information:

<?xml version="1.0" encoding="UTF-8" standalone="yes"?>

<flat-profile xmlns="http://www.sipura.net/xsd/SPA122" xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance" xsi:schemaLocation="http://www.sipura.net/xsd/SPA122 http://www.sipura.net/xsd/SPA122/SPA122-1-3-2-014.xsd">

  <Resync_Periodic ua="na">3600</Resync_Periodic>

  <Resync_Error_Retry_Delay ua="na">3600</Resync_Error_Retry_Delay>

    <Display_Name_1_ ua="na">number</Display_Name_1_>

    <User_ID_1_ ua="na">number</User_ID_1_>

    <Password_1_ ua="na">password</Password_1_>

    <Use_Auth_ID_1_ ua="na">No</Use_Auth_ID_1_>

    <Auth_ID_1_ ua="na"></Auth_ID_1_>

    <Resident_Online_Number_1_ ua="na"></Resident_Online_Number_1_>

    <SIP_URI_1_ ua="na"></SIP_URI_1_>

    <Display_Name_2_ ua="na"></Display_Name_2_>

    <User_ID_2_ ua="na"></User_ID_2_>

    <Password_2_ ua="na"></Password_2_>

    <Use_Auth_ID_2_ ua="na">No</Use_Auth_ID_2_>

    <Auth_ID_2_ ua="na"></Auth_ID_2_>

    <Resident_Online_Number_2_ ua="na"></Resident_Online_Number_2_>

    <SIP_URI_2_ ua="na"></SIP_URI_2_>

</flat-profile>

I can see in /admin/config.xml on the adapter that it downloads and loads the settings for only a couple of seconds, but then quickly reverts back to the settings it had before downloading these - what is going on??

Regards,

Mikael

Everyone's tags (4)
1 REPLY
New Member

Re: Newly fetched settings getting reset all the time (provision

Seems my SPA122 is broken, the same procedure works when I tried another one. Yawn!

288
Views
0
Helpful
1
Replies