Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PAP2 No Audio.

Customer has the following setup:

DSLmodem<><><><><>NETGEAR Router<><><><>PAP2<><><><>Two Analogue Phones.

Customer has subscriber information correct.
Has latest version 3.1.23


Cannot hear anything when making internal calls, no audio on both only dial tone.
When making outbound calls again he cannot hear his clients, however the client can hear customer in a very low tone of voice.

Any ideas to what could be the issue? is it QoS? Thanks in advance.

1 REPLY
Cisco Employee

Re: PAP2 No Audio.

Hi Juan,

Has the device ever been configured and worked in this environment before, or is this a new installation?

How is customer attempting to make internal calls, please describe in detail?

Do inbound calls work without problem?

I doubt the issue is related to QoS. QoS usually results in choppy audio, also called jitter.

Does the customer have  a firewall enabled? If so, please disable and test for one-way audio again.

One-way audio is usually related to NAT and or SPI firewalls that don't allow the seemingly unsolicited RTP through.

Regards,

Patrick

-----------

2043
Views
0
Helpful
1
Replies