You can have two different service providers, one for line 1 and another for line 2.
There's no auto forward from one line to the other but you can setup the call forward say from line 2 to line 1. In the call forward, you'd put something like the userID@ipaddress:port-number of line 1 in the call forward all setting of line 2 (in user 2 tab) so that the calls from line 2 goes to line 1.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...