PAP2T-EU

[Mikhail Chernyakov]

Hello All!

I use CM 6.1.

I try connect PAP2T-EU to CM...

I have not expirience work with Linksys so I can not configure Linksys corret...

Can anybodu provide step by step configuration?

Thank you very much!!!

[Patrick Born]

Hi chernyakov,

Refer to the ATA Admin Guide for registration documentation. https://www.myciscocommunity.com/docs/DOC-2149

Here's a direct link: http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/ata/administration/guide/ATA_AG_v3_NC-WEB.pdf

You should perform the following tasks, in order, so that you start from a known point:

1. Factory reset the device [page 226 in the "How do I access the ATA device if I forget my password?" section]

2. Upgrade to the latest firmware

3. Configure the device to register to your CM [starting on page 39 and then on to page 42]

Regards,

Patrick

----------

[Mikhail Chernyakov]

Hello Patrick!

Thank you very much for useful links...

But I have some trouble...

Sopftware version of my device is 3.1.15(LS)

Is this latest version?

Where can I download new version?

[Patrick Born]

Hi chernyakov,

The current version of firmware is available from http://cisco.com/smallbusinessand then search on pap2t.

You need to log in as a guest, registered user, or partner in order to download firmware.

Regards,

Patrick

-----------

[Ordenador]

Hello, Patrick!

Thank you very much for useful links, but we have some troubles else...

When we dial some number, dialing process last 10 seconds, but we need it last max 3 seconds... How we can configure this parameter?

[Patrick Born]

Hi Ordenador,

You can modify the Interdigit Long Timer from 10 to a shorter time in seconds:

PAP2T web-ui > Regional > Control Timer Values > Interdigit Long Timer: 3

More information in the Admin Guide:

https://www.myciscocommunity.com/docs/DOC-2149

Regards,

Patrick

-----------