Please tell me how to create a generic configuration file for Cisco SPA112 spa112.cfg file that could upload it to any device for SPA112 for preprovisioning? Command spc - xml xxx.xml - target aabbccdd1122 spa112.cfg not true, because the file will only be available with the device MAC address aabbccdd1122. Thank you for your help.
The file preprovisioning_cfg.xml can be modified with a text editor in order to configure only common or general parameters. The file can be uploaded to a SPA via HTTP or TFTP server using one of these special urls:
preprovisioning_cfg.xml is shared through TFTP server http://SPA_IP_ADDRESS/resync?tftp://TFTP_SERVER/preprovisioning_cfg.xml
preprovisioning_cfg.xml is shared through HTTP server http://SPA_IP_ADDRESS/resync?http://HTTP_SERVER/preprovisioning_cfg.xml
Article ID:1966 Network Address Translation (NAT) Settings for Lines on
PAP2T and SPA3102 Phone Adapters Objective The objective of this
document is to configure Network Address Translation (NAT) settings for
the lines of communication on the PAP2T and SP...
Article ID:2742 Speed Dial Settings on SPA100 Series Objective Speed
Dial Buttons are often used to make the process of calling regularly
used contacts quicker and with one button. This option is used in place
of dialing the entire phone number in. This h...
Article ID:2676 Firmware Upgrade on SPA112 and SPA122 Objective To
upgrade the firmware a specific file must be downloaded from the
Internet and uploaded to the device. Upgrading your devices can be very
useful. Firmware upgrades can fix software bugs, im...