Please tell me how to create a generic configuration file for Cisco SPA112 spa112.cfg file that could upload it to any device for SPA112 for preprovisioning? Command spc - xml xxx.xml - target aabbccdd1122 spa112.cfg not true, because the file will only be available with the device MAC address aabbccdd1122. Thank you for your help.
The file preprovisioning_cfg.xml can be modified with a text editor in order to configure only common or general parameters. The file can be uploaded to a SPA via HTTP or TFTP server using one of these special urls:
preprovisioning_cfg.xml is shared through TFTP server http://SPA_IP_ADDRESS/resync?tftp://TFTP_SERVER/preprovisioning_cfg.xml
preprovisioning_cfg.xml is shared through HTTP server http://SPA_IP_ADDRESS/resync?http://HTTP_SERVER/preprovisioning_cfg.xml
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...