You can call out etc etc.. but having trouble with the incomming call. You can call into the line/phone (externally), the internal phone (DECT) will ring, caller ID will display but when you answer the call it is blank (no noise at all, not even static at both ends). If you call back in it will answer and all is working.
Any suggestions with settings, is it a connection delay setting? It seams the ATA needs to be triggered first then its ready to answer as there is also a long pause between finishing the number when calling out and the actial connection. There isnt a problem with the ISP or line etc as it has been working, it with the products/settings.
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...