Routing DIDs to Specific Line Ports of an SPA8000 Thru Single ITSP Trunk
I'm attempting to setup an SPA8000 with a single trunk to an ITSP account that has multiple DIDs, and I need each DID to route to a specific line port on the SPA, but I can't seem to figure out how to set such inbound call routing. Unfortunately, I cannot create sub accounts at my ITSP and set each line individually.
There was a post that was made on the Linksys forums about the same issue, but didn't have a helpful answer to it:
Article ID:1966 Network Address Translation (NAT) Settings for Lines on
PAP2T and SPA3102 Phone Adapters Objective The objective of this
document is to configure Network Address Translation (NAT) settings for
the lines of communication on the PAP2T and SP...
Article ID:2742 Speed Dial Settings on SPA100 Series Objective Speed
Dial Buttons are often used to make the process of calling regularly
used contacts quicker and with one button. This option is used in place
of dialing the entire phone number in. This h...
Article ID:2676 Firmware Upgrade on SPA112 and SPA122 Objective To
upgrade the firmware a specific file must be downloaded from the
Internet and uploaded to the device. Upgrading your devices can be very
useful. Firmware upgrades can fix software bugs, im...