I have added Medatrix and other gateways to our Mitel 3300 conroller, but never a Cisco unit. So we are testing one of the SPA112 for use as a gateway for fax machines. I have the 3300 controller set up with the new DN as a generic SIP device. No issues. Ready to go on the controller side.
However I cannot for the life of me find where I am supposed to set the DN and the IP route to the to the 3300 Mitel phone controller (yes, I scanned through the entire online help doc on the SPA112). Two fields is normally all I have to fill in. The fields are not named even remotely the same as the other equipment I have. Where and what are my two feilds names?
I need to enter:
DN - extension number for the fax machine
IP route to the phone controller - Normally listed in a SIP line list as "SIP Register Address"
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...