cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1991
Views
0
Helpful
4
Replies

setup linksys spa3000's fxo port for work with cucm 8

alinasery62
Level 1
Level 1

hello everybody

i have a linksys spa3000 with software version 3.1.10(GWd).

i have searched for a document about how i can setup spa3000's fxo (connected to pstn)  port works with cucm 8 but i

found nothing.

is there any way to do this?

and is anyone did this before?

4 Replies 4

alinasery62
Level 1
Level 1

please

no one has a clue?

Hi,

Not sure I follow what you are trying to achieve.

Is it SPA3000 --FXO-- CUCM  ?

Regards

Alex

Regards, Alex. Please rate useful posts.

thanks for reply

no

i want to connect fxo port to PSTN line and then with sip to CUCM.

but i don't know how to do this .

i found a link about how to do this in freepbx but nothing for cucm.

the link for freepbx:

http://www.freepbx.org/support/documentation/howtos/howto-linksys-spa-3102-sipura-spa-3000-freepbx

i want to use fxo port for calling outside .

Hi,

On the CUCM side you probably only need to set up a SIP trunk and associated route pattern,list,group etc.

I dont know how to set up a SPA3000

Try asking in the Small Bus Forum

https://supportforums.cisco.com/community/netpro/small-business/voiceandconferencing/voice

Regards

Alex

Regards, Alex. Please rate useful posts.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: