Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

setup linksys spa3000's fxo port for work with cucm 8

hello everybody

i have a linksys spa3000 with software version 3.1.10(GWd).

i have searched for a document about how i can setup spa3000's fxo (connected to pstn)  port works with cucm 8 but i

found nothing.

is there any way to do this?

and is anyone did this before?

4 REPLIES
New Member

setup linksys spa3000's fxo port for work with cucm 8

please

no one has a clue?

Green

setup linksys spa3000's fxo port for work with cucm 8

Hi,

Not sure I follow what you are trying to achieve.

Is it SPA3000 --FXO-- CUCM  ?

Regards

Alex

Regards, Alex. Please rate useful posts.
New Member

setup linksys spa3000's fxo port for work with cucm 8

thanks for reply

no

i want to connect fxo port to PSTN line and then with sip to CUCM.

but i don't know how to do this .

i found a link about how to do this in freepbx but nothing for cucm.

the link for freepbx:

http://www.freepbx.org/support/documentation/howtos/howto-linksys-spa-3102-sipura-spa-3000-freepbx

i want to use fxo port for calling outside .

Green

setup linksys spa3000's fxo port for work with cucm 8

Hi,

On the CUCM side you probably only need to set up a SIP trunk and associated route pattern,list,group etc.

I dont know how to set up a SPA3000

Try asking in the Small Bus Forum

https://supportforums.cisco.com/community/netpro/small-business/voiceandconferencing/voice

Regards

Alex

Regards, Alex. Please rate useful posts.
1485
Views
0
Helpful
4
Replies
CreatePlease to create content