On the UC 560 device we have an ACL that is wrong and need to be redone entirely.
I have read that if we remove or modify an ACL tie to a VPN, the VPN will be unstable.
If we add a rule to an existing ACL this is considered acceptable.
So as I understand since the ACL is wrong and tie to the VPN, it is better to redo the site to site VPN entirely and this time enter the correct parameter? (I will do a check on the ACL just to be sure there is no remanant wrong ACL remaining.
Is there a way to identify the ACL tie to a VPN or Interface? I just want to clean as much as possible before redoing the site to site VPN.
Network Address Translation (NAT) Settings for Lines on PAP2T and SPA3102 Phone Adapters
The objective of this document is to configure Network Address Translation (NAT) settings for the lines of communication on the PAP2T ...
Speed Dial Settings on SPA100 Series
Speed Dial Buttons are often used to make the process of calling regularly used contacts quicker and with one button. This option is used in place of dialing the entire phone number in. ...
Firmware Upgrade on SPA112 and SPA122
To upgrade the firmware a specific file must be downloaded from the Internet and uploaded to the device. Upgrading your devices can be very useful. Firmware upgrades can fix software bu...