Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

SPA 112 Does Not Recieve Calls After a While

Hi using SPA112.

Device stops responding the calls (I see that the Line1 is registered) after a while.

 

Unless I do a Factory Reset for voice setup, device does not respond to calls (phone does not ring and the calling party receives busy tone) but I can make outgoing calls.

Current FW is 1.3.5. I already tried to use 1.4.0 but did not fixed anything.

Any suggestions?

Best,

Everyone's tags (1)
1 REPLY
Cisco Employee

SPAs are supported in the SMB

SPAs are supported in the SMB community, I suggest you move this over there.

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
67
Views
0
Helpful
1
Replies
CreatePlease to create content