we have a setup with a e1 line on a mgcp trunk and a SPA3102 ( Fw version: 5.2.13(GW002) - Hw version: 1.4.5(a)) We're using modem passthrough on trunk, and gw network clock is sync'ed with the E1 clock.
The ATA is configured as a 3d party sip phone, outbound faxes seem to work but inbound faxes do not arrive correctly: we're able to hear from "outside" the fax tone, but we got a transmission error.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...