Re: SPA 3102 & SPA2102 have too short dial tone time.
The regional tab:-
Call Progress Tones
Second Dial Tone:
Outside Dial Tone:
Off Hook Warning Tone:
All show ;10( as you suggested, but I've tried various longer and shorter times for both "Dial Tone" and "Reorder Tone" but no change from the 3 second timeout.I wondered whether the Reorder Delay which was set at 3, could be the problem, so changed to 10 with no effect.
Control Timer Values (sec)
Hook Flash Timer Min:
Hook Flash Timer Max:
Callee On Hook Delay:
In case it is relevant, my dial plan is:-(13[1-9]xxxS0|100xxxxxxS0|190xx.!|0011xx.!|0[2-9]xxxxxxxxS0||<9:089>xxxxxxxS0 |<:089574>[2-8]xxxS0 )My software Version is 5.2.10It may be relevant that after the Dial Tone times out (in 3 sec) I do not get Reorder Tone but it just goes dead!RegardsMaurice
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...