I have some Cicso spa112, and i use them to connect with my mitel 3300, and my problem is, if i use them with my PRI line, i dont have problem to make call, but this week, we switch to SIP trunk line, and we are not able to make external call, when we dial, we receive after a few second, a message about that we are not able to proceed to the call. We are able to receive call internal and from external only via mitel 3300.
I tried to change some setting on the device without success.
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
This document is a must-read for all SPA232D installers, administrators,
and users. The document takes you from unboxing the SPA232D ATA and
SPA302D DECT handsets, through DECT handset registration, and connecting
to the PSTN and ITSP.The document describ...
Device: SPA112Firmware: 1.3.2 SPA112 accepts 101 to set internet
addressing method from dynamic to static but does not change the actual
value. Error message - Set Static IP (INTERNET PORT) 111: Invalid
option. Resolution Summary: . Step 1 : Press **** . ...