Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SPA112 no outbound FAX with T.38 possible.

Hello,

just got a brand new SPA112 for FAX testing.

Tried two different operators which have T.38 support with no luck. SPA2102 works well with that operators.

Inbound calls works perfectly, T.38 is used, fax 100% OK.

Outbound call fails everytime. T.38 is recognized and applied as I can see on status page. Unfortunately after about 40-50s it fails.

Tried with three different fax machines and to four different kind of receiving fax machines/lines, both physical and virtual.

Also tried to upgrade firmware to 1.1.0(011) but nothing has changed.

Here is my Audio config.

fax.jpg

Any hint?

Thanks

Everyone's tags (4)
4 REPLIES

SPA112 no outbound FAX with T.38 possible.

Can you add a log file of the SPA during a failed call?

Regards.

New Member

Re: SPA112 no outbound FAX with T.38 possible.

ciao Daniele,

here is the log.

http://www.infovi.net/trace-fail.pcap

New Member

Re: SPA112 no outbound FAX with T.38 possible.

it is not a SPA log, of course, it is the pcap trace

Re: SPA112 no outbound FAX with T.38 possible.

The remote fax send an FTT (failure to train) used to reject a training signal and request a retrain (retrains usually occur at lower modulation speeds).

This is a working t38 flow:

Try to disable ECM and add a new trace.

Regards.

5600
Views
0
Helpful
4
Replies
CreatePlease to create content