I just bought SPA112 and tried to install it. After connecting ethernet link, two phones and power, Power led started to blink fast for about 2 minutes. After this now it is solid green but other leds are not working. I cant connect to SPA via www - router coudn't see this SPA. I know that it is not a problem with Etherned link beacuse to this router I have connected another SPA112 and it is working correctly. Any ideas?
If other SPA112 has ethernet link on the cable, but this device has no link here, then it's broken SPA. You can reset it to factory default using the reset button, but the is nearly no chance it will help. Return it to seller then.
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
This document is a must-read for all SPA232D installers, administrators,
and users. The document takes you from unboxing the SPA232D ATA and
SPA302D DECT handsets, through DECT handset registration, and connecting
to the PSTN and ITSP.The document describ...