SPA122 cannot access web configuration utility

[glavrenov]

The new SPA122 device connected to router through DHCP.

I can see IP-address on router's web page, can ping it, and receive it with ****110# IVR command.

But I cannot access web configuration utility in the browser: the page is unavailible. I tried to allow WAN access with ****7932#1#1 IVR action - the problrem still on.

Can You give me any advice what to do.

[Dan Lukes]

Password must be set to non-default value.

Read

[Dan Miley]

You can also connect to the lan/ethernet side of the device, do an ipconfig /renew

You should get an address on the 192.168.15 network, the default for the router in the ATA is 192.168.15.1

Then you can set up the non default password, enable the wan web server (administration tab I think).

dlm...

[glavrenov]

Thanks to everybody for the answers. I connected to device with LAN port and entered web configuration.

[Dan Lukes]

Rate usefull advices. It will help others to found valuable help.