SPA122 - certain incoming calls cause the device to de-register + other issues
We have had a few only going issues with these devices since having to change to them when the 2102 was discontinued.
At this stage we have two issues:
1. Provisioning via TFTP causes the bridge mode in the device to not work, we have got a beta release FW that fixes this '1.2.0(023)'
2. Certain calls to the device causes the adapter to de-register the voice connection to our server, the phone rings once at the clients end, they pick it up, but no one is there, the phone is then unusable after this as its deregistered. This happens on the beta FW version and also on the shipped FW version '1.0.1(022)' however it seems to be ok on '1.1.0(011)', but on this version the provisioning does not work.
I would be interested to see if anyone else is having the issue in point 2, these devices seem to no where near as stable as the 2102's
Anyone got a few hundred 2102's that want to sell? NZ
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...