Hi all, I recently purchased a SPA122 ATA. I have one phone connected to it. I have accounts at two different Voip service providers. I would like the SPA112 to select one of the two proxies depending on the number dialed on the phone. E.g. when dialing 0123456 the call goes over proxy1 and all other numbers go over proxy2. Is this possible? Although there seem to be a million configuration settings I have not found a way to do it - instead, it seems like a physical input (line) is connected exactly to one proxy and I would need a second phone? Thanks for you help!
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...