just purchased the spa122, connect the laptop to the unit and access 192.168.15.1, it shows the login, after login, the first thing it asks for is Recovery Firmware v1.0.2 (001), not sure why, went to download the latest version v.1.3.2-XU, start upgrade, if seems completed, but power light keep flashing and waited over 15 minutes and no response. Reset the unit and access via the I22.214.171.124, login and it asked for firmware recovery again.
Did it several times, keep asking for firmware recovery. Anyone knows why? this is a new unit, just out of the box.
No, I am not able to access the GUI, when I access 192.168.15.1, it asks for login, I use admin and admin, get it and then it shows Firmware Recovery v1.0.2 (001), I downloaded the latest version and go through the upgrade, and reset and it still comes back to the same screen.
I did try different version for firmware it all end up the same. I cannot even see the GUI at all.
I contacted support, they said it is a defective unit, and asked me to return to supplier, I just want to make sure this is the case before sending the unit back.
But after trying a few times, I think the tech is right, I am convinced that this is a bad unit.
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
This document is a must-read for all SPA232D installers, administrators,
and users. The document takes you from unboxing the SPA232D ATA and
SPA302D DECT handsets, through DECT handset registration, and connecting
to the PSTN and ITSP.The document describ...