My client has an SPA122 Software version 1.1.0(011)
He needed to have STUN turned on and a STUN server IP entered. I put the entries into a configuration file, which his device loaded and was able to get on the network (so it must have loaded the STUN settings).
However, when he used the web to look at the settings in his device - STUN is OFF and the STUN Server entry is blank.
This is not stopping the device from working -- but is rather confusing for the client.
Article ID:1966 Network Address Translation (NAT) Settings for Lines on
PAP2T and SPA3102 Phone Adapters Objective The objective of this
document is to configure Network Address Translation (NAT) settings for
the lines of communication on the PAP2T and SP...
Article ID:2742 Speed Dial Settings on SPA100 Series Objective Speed
Dial Buttons are often used to make the process of calling regularly
used contacts quicker and with one button. This option is used in place
of dialing the entire phone number in. This h...
Article ID:2676 Firmware Upgrade on SPA112 and SPA122 Objective To
upgrade the firmware a specific file must be downloaded from the
Internet and uploaded to the device. Upgrading your devices can be very
useful. Firmware upgrades can fix software bugs, im...