Did you check another device (e.g. your PC) connected directly to the internet to see if you receive an IP address?
if you mean on the router port where i am conneceted cable the comming from the BLUE(Internet port of spa2100), then yes i have check all port on the router and also test all cable, using laptop to get ip from router on each port.
If you are able to get the IVR, it does not look like a device problem but a network one...
Yes, this is confusing as IVR work, i even tried setting up static WAN IP on the spa2100, but still it does not comunicate, and LED (orange) on the SPA2100 Internet port does NOT come on, as looks that the cable is not even connected. Compare to, atleast on LAN port LED turn on ORANGE when cable is connected. But LAN port does not give IP to PC if connected directly, therefore not able to even go on the WebUI. I have tried you setup static ip on the PC matching the LAN ip of the SPA2100 (same subnet), LED comes on both sided but WEBUI still not work.
I think the Firmware is corrpted, but not sure how to flash without connecting to PC.
To eliminate the possible network problem, factory reset your 2100 by dialing the ivr and entering 73738# and 1 to confirm. Then get back into your ivr and dial 7932#, 1#, and 1 to confirm. This will enable web interface management on your SPA2100. Then attach it to your router. Check your router's dhcp client's table for the mac address of the SPA2100, or dial the ivr and enter 110#, and get the IP of the WAN interface. Put that address in your browser, and you should be able to manage it then. If that doesn't work, it may be a hardware issue. Your LEDs should be green when cables are attached. The power will be flashing until an ip address is aquired, and the phone LED will be solid when a phone is attached and Line1 is registered.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...