Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SPA2102 Caller ID issue

We have replaced an old Cisco ATA188 SIP with a new SPA2102.

After this substitution we encountered a Caller ID problem.

The analog phone connected to SPA doesn't show the CID any more.

We have tried every possible combinations available on the SPA without success (Bellcore, ETSI FSK, ETSI DTMF, bell 202, v23, etc).

This is the working Cisco ATA 188 config:

RingOnOffTime 1,4,25

CallerIdMethod 0x00018066 hex  =  11 000000 001100 1 10 bin
bit 0-1=2 ETSI
bit 3=1 send after first ring

bit 3-8=12 maximum number of digits

bit 9-14=0 maximum number of chars

bit 15=1 send out ouf area if cli is unknown

bit 16=1 send privete if cli is restriceted

What are equivalent parameters of the SPA? Is there a bug on ETSI FSK Caller ID method?

Regards.

1 REPLY

SPA2102 Caller ID issue

This is the working configuration:

RingCadence: 60(1/4)
Caller ID Method: Bellcore
Caller ID FSK Standard: bell 202
Idle Polarity: Reverse

2484
Views
0
Helpful
1
Replies
CreatePlease to create content