Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SPA2102 POINT TO POINT with 3660 with FXS without SIP server

Hi,

I' need some information about if it's possible to configure a 3660  router with 2 FXS interface to communicate with SPA2102.

I' d like to know which is the configuration that i have to set up on the 3660 to do voice call with a spa2102.

It's sufficient configure this parameters:

dial-peer voice 1 pots

destination-pattern 901 (my phone number)

port 5/0/0

!

dial-peer voice 200 voip

destination-pattern 201

session target ipv4:xx.xx.xx.xx (ip address spa2102)

session  protocol sipv2

Thanks a lot and Best Regards

Carmine

2 REPLIES

SPA2102 POINT TO POINT with 3660 with FXS without SIP server

Yes, your config is sufficient.
This is my configuration:

voice call send-alert
voice rtp send-recv

dial-peer voice 1 voip
description INCOMING_DIAL_PEER_INCOMING_CALLS
incoming called-number .
modem passthrough nse codec g711alaw
voice-class codec 10
fax protocol pass-through g711alaw
no vad
!
dial-peer voice 2 voip
description TO_REMOTE GATEWAY

huntstop
destination-pattern 5..
modem passthrough nse codec g711alaw
session protocol sipv2
session target ipv4:IP_ADDRESS_REMOTE_GATEWAY

session transport udp
dtmf-relay rtp-nte
codec g711alaw
fax rate disable
fax protocol pass-through g711alaw
no vad
!
dial-peer voice 10 pots
description FROM_REMOTE_GATEWAY

huntstop
destination-pattern 610
port 2/0

sip-ua
disable-early-media 180
max-forwards 10
retry invite 3
timers expires 60000
no suspend-resume

Change Line parameters of your SPA2102 as shown in the figure below and configure appropriate phone numbers.

Regards.

New Member

SPA2102 POINT TO POINT with 3660 with FXS without SIP server

Thanks a lot

Carmine De Rienzo

701
Views
0
Helpful
2
Replies