I have an SPA232D DECT ATA with 3 SPA302D handsets registered. No SIP connections.
What I want to do is be able to send a hook flash event and dial a star code (i.e. *98 - blind call transfer) on the PSTN line when I have a current call on the line. If I use a cheap walmart handset I can accomplish this during a call by pressing the "flash" button, dialing *98, dialing the transfer extension, and hanging up. What am I missing here to make this work with a much more sophisticated set of cordless phones?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...