When using the SPA302D caller ID for the number comes up as a series of x's. The display name is there (support, sales, Cameron) but the number below just shows as xxxxxxxxxxxxx.
If you press call it does call the number but just displays the x's. How do you get it to display the actual number?
I also have a uniden HS910 that I use with my SPA514G and it works perfectly. With the SPA302D though, it does not have any speaker noise. The caller can hear me but I cannot hear them via the headset.
Article ID:1966 Network Address Translation (NAT) Settings for Lines on
PAP2T and SPA3102 Phone Adapters Objective The objective of this
document is to configure Network Address Translation (NAT) settings for
the lines of communication on the PAP2T and SP...
Article ID:2742 Speed Dial Settings on SPA100 Series Objective Speed
Dial Buttons are often used to make the process of calling regularly
used contacts quicker and with one button. This option is used in place
of dialing the entire phone number in. This h...
Article ID:2676 Firmware Upgrade on SPA112 and SPA122 Objective To
upgrade the firmware a specific file must be downloaded from the
Internet and uploaded to the device. Upgrading your devices can be very
useful. Firmware upgrades can fix software bugs, im...