I have just set up a SPA3102 on my internal network, and have connected it to the PSTN.
I want to be able to route incoming calls on the PSTN to a IP phone (a Snom 360), and also make outgoing PSTN calls on the Snon. For the moment, it is just one IP phone, but I do want to add further phones in later.
However, the Snom only seems to be able to do this if it is registered through SIP, but I can not see how you can accept SIP registrations on the SPA3102.
Does any one have any sugestions or advice please.
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
This document is a must-read for all SPA232D installers, administrators,
and users. The document takes you from unboxing the SPA232D ATA and
SPA302D DECT handsets, through DECT handset registration, and connecting
to the PSTN and ITSP.The document describ...
Save yourself hours or even days of searching for ATA resources by using
this document!Turn View Bookmarks on when viewing the document for best
navigation. [View > Navigation Panels > Bookmarks]Use the links in this
document to easily locate resources re...