Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

SPA3102 as simple FXO/SIP gateway, no router?

Hi,

 

Has anyone set up a SPA3102 as a simple gateway between the FXO PSTN line and an internal SIP PBX (Asterisk or similar)?  I don't want the thing trying to act as a router; it will be on the same LAN segment & subnet as the PBX machine and just needs to provide a 2-way SIP trunk that's actually the PSTN line.

 

Would this work with just the WAN port connected, or perhaps with both ports on the same segment & subnet, or would that confuse it?

 

Thanks!

 

Jeff

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

SPA3102 as simple FXO/SIP gateway, no router?

Hi Jeff,

You could deploy it in bridge mode if you don't want it acting like a router:

    Router tab > Lan Setup > Networking Service > Bridge

Regards,

Patrick---

2 REPLIES
Cisco Employee

SPA3102 as simple FXO/SIP gateway, no router?

Hi Jeff,

You could deploy it in bridge mode if you don't want it acting like a router:

    Router tab > Lan Setup > Networking Service > Bridge

Regards,

Patrick---

Community Member

SPA3102 as simple FXO/SIP gateway, no router?

That did the trick, thanks!

705
Views
0
Helpful
2
Replies
CreatePlease to create content