I've previously been running v3.something of the firmware which allowed you to set the FXS port impedance to 370+620||210nF which was the standard all the instructions told you to use for a UK BT Line.
I've now upgraded to version 5.1.10 of the firemware and this option is no longer available. I've currently got it set to the default 600, but im getting some echo on the line.
Is this a bug that the 370+620 isnt available or should it now be set at a different level.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...