Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SPA3102 & Incoming PSTN Distinctive Ring

I understand the SPA3102 uses disticntive ringing when it sees a specific caller-id, but can it detect an incoming pstn calls distinctive ring? If not, how does it detect the ringing & it it possibe to enter a cadence for a distinctive ring and have it detect that?

I've seen post on the net from 2004 that acknowledge that this feature didn't exist back then. Here's hoping things have advanced in 5 years.

Thanks,

Raoul

3 REPLIES
Cisco Employee

Re: SPA3102 & Incoming PSTN Distinctive Ring

Hi Raoul,

The Admin Guide describes the SPA3102's distinctive ring capabilities in detail.

Available from: https://www.myciscocommunity.com/docs/DOC-2149

Direct link: http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/ata/administration/guide/ATA_AG_v3_NC-WEB.pdf

Regards,

Patrick

----------

New Member

Re: SPA3102 & Incoming PSTN Distinctive Ring

Hi Patrick,

I've previously read that Guide (which incidentally also covers all other Linksys ATA devices, which makes figuring out if which device you're reading options for rather difficult) and it really wasn't much help apart from listing options, hence my my last resport post here.

I take it that the SPA3102 doesn't detect incoming pstn call distinctive ring?

How does it detect rings then?

Regards,

Raoul

Cisco Employee

Re: SPA3102 & Incoming PSTN Distinctive Ring

Hi Raoul,

No, the SPA3102 does not detect incoming PSTN call distinctive ring.

The only way to use distictive ringing is with the caller id method that you have already seen.

Regards,

Patrick

----------

3208
Views
0
Helpful
3
Replies
CreatePlease to create content